CYBEX 400T Guía de usuario descargar pdf (Pagina 51)

Symptom Action

OSD menu does not “pop-up” Verify that you are pressing the Control key twice

within one second. If the problem persists, contact

Cybex Technical Support.

Unable to change channels Verify that the channel is powered. Check the

using OSD address configured in OSD. If the computer is

powered and the address is correct, call Cybex

Technical Support.

Administrator password is Call Technical Support.

forgotten

User password is forgotten Contact your system administrator.

General Keyboard/Video If the building has 3-phase AC power, ensure

Problems that the computer, the AutoView 400 and the

monitor are on the same phase. Best results are

obtained when they are on the same circuit.

Use only Cybex supplied cable. Cybex warranties

do not apply to damage resulting from user

supplied cable.

Do not use a 2-wire extension cord in any Cybex

product configuration.

Test AC outlets at computer, AutoView 400 and

monitor for proper polarity and grounding.

Use only with grounded outlets at the computer,

AutoView 400 and monitor. When using a backup

power supply (UPS), power the computer,

AutoView 400 and the monitor off the supply.

Appendices

1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Sin comentarios

CYBEX 400T Guía de usuario Pagina 51