CYBEX 400T Guía de usuario descargar pdf (Pagina 17)

Attaching Multiple AutoView Units

(Please note that cascading can only be done with CUFC, CIFC or CIFCA cables)

1. Follow steps 1-8 of the Basic Install section for each cascaded unit.

2. Plug the 25-pin “D” connector of your input cable into any available

channel port on the rear of your base AutoView unit.

3. Plug the 15-pin video connector on the other end of the cable into the

port labeled

on your first cascading AutoView unit. Plug the PS/2

mouse connector, designated by a yellow band or mouse icon, into the

port. Plug the remaining 6-pin miniDIN keyboard connector into the

port.

4. Follow steps 9-11 in the ‘Connecting Computers to the AutoView 400’

section for each attached compter.

5. Repeat steps 2-3 for every cascaded AutoView unit in your system.

6. Power-up your AutoView unit(s) first, then all attached computers.

Basic Installation

Advanced Install

CASCADING

UNIT

BASE UNIT

VGA MONITOR CABLE

PS/2 MOUSE CABLE

PS/2 KEYBOARD CABLE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Sin comentarios

CYBEX 400T Guía de usuario Pagina 17