CYBEX 400T Guía de usuario descargar pdf (Pagina 16)

AutoView 400 Installer/User Guide

11. Locate the power cord that came with your AutoView 400 unit and plug

it into the IEC power connector on the AutoView 400. Make sure that the

power switch is off, then plug the other end of the power cord into an

appropriate AC wall outlet. This outlet must be near the equipment and

easily accessible to allow for unplugging prior to any servicing of the

unit.

12. Power-up your AutoView 400 unit first, then power up all attached

computers.

13. If your remote user location utilizes Sun peripherals you will

need to set the AutoView 400 to recognize them before they can be

used. To do this:

a. Activate the on-screen display (OSD) by pressing either of the

keyboard Control keys twice within one second.

b. Press the Control keys twice more to access Administrator Com-

mands.

c. Use your arrow keys to highlight “Administrator Functions” and

press Enter.

d. Highlight and select the “Remote User” menu selection. Use the

space bar to cycle through peripheral types and select the ones

appropriate to your system. Press Enter to select.

The AutoView 400 and all attached computers should be

powered-down before servicing the unit. Always disconnect

the power cord from the wall outlet.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Sin comentarios

CYBEX 400T Guía de usuario Pagina 16