CYBEX AUTOVIEW COMMANDER - Guía de usuario descargar pdf (Pagina 14)

AutoView 200 Installer/User Guide

100-240V , .1A, 50/60 Hz

11. Locate the power cord that came with your AutoView 200 unit. Plug it

into the IEC power connector on the AutoView 200. Make sure that the

power switch is off, then plug the other end of the power cord into an

appropriate AC wall outlet. This outlet must be near the equipment

and easily accessible to allow for unplugging prior to any servicing of

the unit.

12. Power-up your AutoView 200 unit first, then power up all

attached computers.

The AutoView 200 and all attached computers should be

powered-down before servicing the unit. Always discon-

nect the power cord from the wall outlet.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 46 47

Sin comentarios

CYBEX AUTOVIEW COMMANDER - Guía de usuario Pagina 14